DAS Forum für Yamaha XT600 und XT600Z

We've had an SW Motech carrier on our 3TB for years. Great fit and well worth the money.

I bought a FZ600 rear disc. 220mm with correct bolt spacing. Now I need to use countersunk screes and mill my caliper a few mm. https://i.postimg.cc/QtBrY7Ld/20240218-174313.jpg But I have a bigger problem to solve at the moment!!! https://i.postimg.cc/nhVgwmBf/IMG-20240220-WA0011.jpg My MG Stelvio ...

lowrider82 hat geschrieben: ↑

Di 30. Jan 2024, 12:36

What is a wee spacer?

Small
The XT600 spacers and the brake hanger aren't quite correct. Using the XT600 caliper and brake hanger so will possibly have a disc manufactured as the TDM is of larger diameter. But that plan may change.

Rear went in OK. Just need to make up a wee spacer.

Did you get this sorted ?
My thread guy, Threadworx
https://www.threadworx.co.uk/
, will take it out for £30, he's in England so there's shipping I guess. You could send it to me and I'll pop over. I have one that needs a bleed nipple removed

Message me.
Cheers

Using the brace and mudguard from XTZ660, I attached this to my XT600 3TB with u bolts. Brace needed piece welding to extend align one bolt hole. https://www.ebay.co.uk/itm/256324907795?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=vRVJ5XgSSd-&sssrc=4429486&ssuid=uVFKE3LnSqy&...

How many turns out is your air screw ?

Cheers
Min

Yes, I see what you mean. As much as I loved my SRX , which made me grin every time I rode it, it wasn't what I needed day to day around London. Yes, it was skinny to get through traffic, but a wee bit physically small for me. Had an engine rebuild by Slipstream in England . Mildly tuned, he built S...

TDM front end is a straight swap.



Cheers
Min

Very old topic but I am new here.
My fault for this problem was in the left hand switch. No speedo light equals no tailight.